ScyllaDB Docs ScyllaDB Enterprise ScyllaDB for Administrators Procedures Cluster Management Procedures Add a Decommissioned Node Back to a ScyllaDB Cluster

Add a Decommissioned Node Back to a ScyllaDB Cluster¶

This procedure describes how to add a node to a Scylla cluster after it was decommissioned. In some cases, one would like to add a decommissioned node back to the cluster, for example, if the node was decommissioned by mistake. The following procedure describes the procedure of doing that, by clearing all data from it, and adding it as a new node in the cluster

Prerequisites¶

Before adding the new node again to the cluster, we need to verify that the node was removed using the nodetool status command.

For Example:

The decommissioned node’s IP is 192.168.1.203. Notice that this node is not in the cluster.

Datacenter: DC1
  Status=Up/Down
  State=Normal/Leaving/Joining/Moving
  --  Address        Load       Tokens  Owns (effective)                         Host ID         Rack
  UN  192.168.1.201  112.82 KB  256     32.7%             8d5ed9f4-7764-4dbd-bad8-43fddce94b7c   B1
  UN  192.168.1.202  91.11 KB   256     32.9%             125ed9f4-7777-1dbn-mac8-43fddce9123e   B1

Procedure¶

1. Stop the decommissioned node using

sudo systemctl stop scylla-server

docker exec -it some-scylla supervisorctl stop scylla

(without stopping some-scylla container)

2. Delete the data and commitlog folders

sudo rm -rf /var/lib/scylla/data
sudo find /var/lib/scylla/commitlog -type f -delete
sudo find /var/lib/scylla/hints -type f -delete
sudo find /var/lib/scylla/view_hints -type f -delete

Since the node is added back to the cluster as a new node, you must delete the old node’s data folder. Otherwise, the old node’s state (like bootstrap status), will prevent the new node from starting its init procedure

3. Follow the Adding a New Node Into an Existing Scylla Cluster procedure to add the decommissioned node back into the cluster

Was this page helpful?